netgear genie port forwarding not working

#Netgear genie port forwarding not working how to

There is a good network cable connected between the DVR and the router.

If you don't see your DVR's IP address, then double check the following: For this router, select the option 'My Connected Home.' If you added your DVR to your network as you should have in the previous guide, then it should be listed as an option under Connected Devices. On the top bar of this particular router there should be choices for different sections. If you do not know this you can check the manufacturer's default login, or call your internet service provider. Once you bring up this page you should then be prompted for your login credentials.

#Netgear genie port forwarding not working how to

You can also read this article on how to find your router's ip address. For Frontier users this should be something like 192.168.254.254, depending on your home network.

To do this you go to your internet browser and type in the Default Gateway (Router IP Address). If not you can follow the guide here: įirst you must access your router to make any port rules. The first thing you should do is gather the necessary networking information about your system, which you should already have done. Two rules must be made, one for Port 80 and one for Port 37777. As example we will use port numbers for our Security DVRs. This guide can be used to configure port forwarding rules for any device on the Frontier Netgear B90-75502 router. If you have this router follow the steps in this article below to setup port forwarding for your surveillance system. This article is dedicated to configuring port forwarding with the Frontier Netgear B90-75502. In security camera systems this is very important, without it you cannot see your security cameras when away from home. Using this port forwarding feature you can instruct the router firewall to allow select traffic from the internet to access a device on your local network. Frontier Netgear router port forwarding is also called Enable Applications.